Dwelling Improvement Stack Exchange is a question and answer web site for contractors and severe DIYers. It’s 100% free of charge, no registration essential.
This is so that the door can be picked up enough so that the roller assembly can clear the bottom track. Removal is generally very basic raise the door further into the best track and pull the bottom towards the inside. If the inside room is a hardwood floor or even vinyl tile flooring it is encouraged that some type of cover be provided to sit the door on so as not to scratch or dent the flooring. Continue this process till the best of the door comes totally free from the upper track and removal is comprehensive. If you have problems performing this it may well help to adjust the rollers entirely up into the door see the final paragraph for guidelines on adjusting the rollers.
I am considering that the lack of rod length is causing you to shed the latching speed adjustment? Or is the door not capable to open as totally as you would like? If it is the former difficulty, then you can either extend the rod as you recommend (weakening the arm) or place a 1 inch thick shim on the door to make up for the shortage (lame and ugly). If it is the latter difficulty, move the closer to the 121-180 degree opening template place. Then you will be capable to open the door wider.
My old stereo ($20 in 1980) sits atop a lengthy coffee table (discovered in alley) below the window. The corner table was left by a tenant. The center art piece above the couch is an original ink and watercolor by an old buddy, Rob Maher, from back in Minnesota. It was offered to me. I paid 25 cents for the black shawl positioned above the artwork, then paired one on the opposite wall. Dang factor cost two bucks!
In order to make the installation, the installer will have to reinforce the door. This could be carried out with metal or plywood plates. On the pull side of the door, the plate need to be flush with the top of the door so that it can be screwed to the thin strip of wood inside the best of the door. On the push side, the plate ought to be by way of-bolted to the other plate. Between the inside and outdoors plates, use copper tubing to produce sleeves for the by way of-bolts so as to aid quit them from crushing the door.