Bandsaw 14 Rubber Tires (2)
Appear For Cheap Bandsaw 14 Rubber Tires On the internet. Study Bandsaw 14 Rubber Tires & Examine On Bandsaw 14 Rubber Tires.
I smeared glue on the neck surface and a small on the physique where the fret board would lay then clamped down the neck, wiping off the squeezed out glue with a wet paper towel as I went. I needed to use a C-clamp to attach the fret to the body, considering that there is a slight bend expected due to the set back angle of the neck. I hope the strings will clear the frets in this area. Soon after the glue dried I located the top of the fret board had slipped sideway slightly, even although I attempted to stop this. I’ll will need to do some sanding and stain touchup.
When all the frets have been pressed in, I trimmed the edges with wire cutters then filed them flush with the fret board binding. Due to the fact the frets are only held in the slots by the barbs, there is a slight gap left in the slot. I wicked super glue into the slots utilizing whip guidelines which I purchased from Stew-Mac. These handy small tips slide proper onto the bottle tip. I made use of some paste wax on every side of the fret wire to hold from slopping super glue onto the wood. This turned out to be a mess. The paste wax dried white, leaving white residue in the wood grain, and I slopped super glue on the wood anyway.
Now, place the starting point mark on your band saw blade straight more than the beginning point mark on your flat surface and begin to roll the blade forward. Hold the blade rolling as straight as feasible (working with a guide …
Bandsaw 14 Rubber Tires (2) Read More