Etching is a step that at times gets overlooked when it comes to applying garage floor paint. Nevertheless, for an epoxy coating to be capable to properly do most of its job, etching is certainly necessary. Most garage floor coatings can be applied, and will likely last for a whilst devoid of etching initial, but there are fairly a handful of advantages to etching that make it worth carrying out, in most people’s opinions.
The trip-and-fall hazard can be reduced by grinding down the edge, tapering it back towards a level area and filling any cracks. (Resist the temptation to grind off far more than about 1/3 of the thickness of the slab as it will weaken the slab also a lot.) Your floor won’t be perfectly flat but the safety hazard will be substantially reduced. Once more, mainly because of the hazards involved, we highly advocate that you have a professional do the grinding.
My little boys room has a quite damp smell to it, especially on a single side of the space which backs onto a bathroom. The skirtings are very old and have a few gaps…however there is no mildew or mould that I can see, just a extremely old damp smell. Could you please give me some advise on how to get rid of it, as worried about well being implications. Thanks!
I have never coated a floor just before. I place this Garage floor paint on a basement floor yesterday and it worked great! You just have to stick to instructions. Study the instructions. Did you get that? Read the instructions. Look at the directions as to the temperature the floor is and operate according to that also. Try to remember to mix the two cans and wait for the needed amount of time prior to putting on the paint! Read the guidelines! Do 4 x four foot locations then sprinkle on the sprinkles (or whatever you call them) if you want to. I did and it looks good!
Do not apply a sealer or floor paint to a garage floor that doesn’t have a vapor barrier, considering the fact that the finish will not adhere nicely to the surface. There is small you can do to appropriate this difficulty other than removing the current slab and pouring a new 1 with a vapor barrier beneath it, or put a vapor barrier on top of the current slab and pouring further concrete (minimum of 3” thick) on leading of it.
